Out of stock, New stock arriving Late December
This Smart EV Charger allows you to have full control by making use of the app to set charge schedules, automatic output adjustment based on Solar generation, adjust the current as well as monitoring power usage
It features a Type 2 cable for most NZ new cars.
If you have a car with a Type 1, then grab our untethered version
Plug and charge mode for use with out the app. Or secure mode locked using the app
Scheduled charging – edit and add multiple schedules.
Dynamic load balance to monitor your house hold current.
32A 7.2KW Charging or vary the charge rate from the app.
IP54 weather proof and can be mounted outdoors with no issues.
Input cable can be installed from the bottom or the back to hide the cable.
Led indicator ring light around the charge port
OCCP 1.6j Compatible
App compatible with Apple and Android
Attached Type 2 cable
This charger is able to add around 50km of charge per hour to your car.
Dynamic load balance
Optionally install the included CT clamp at the mains and this will monitor your total house draw. If this draw exceeds the maximum limit the charge rate will be reduced to avoid tripping the breaker.
Great if you are on a power plan that offers free power and you want to have all your appliances running at the same time.
With the included second CT clamp installed on the output of your inverter the charger will automatically adjust its output to match what your solar is generating.
So if you are generating 20a of solar this will be diverted to your car. The minimum a car can charge is 6a, so when the sun goes behind a cloud it will be grid fed 6a to avoid constantly going on and off.
200mm x 330mm x 132mm
Over Temperature protection
Overload Current protection
Over/under voltage protection
DC and AC leakage protection (No need to install a Type B RCD to keep the cost of install down)
1x Charger with attached 5m cable
1x CT clamp for load balancing
1x CT clamp for Solar balancing
1x Type 2 cable holder
Save money on your install by picking up an External switch and Type A RCBO, electricians typically charge $300 for both, get ours for $88
No Type B RCD needed when installing, If you have limited room on your switch board pick up one of our mini Type A RCBO at the same time.
Wi-Fi is required for initial setup of the app, or the charger can be put in to plug and charge mode without Wi-Fi. A Wi-Fi extender is recommended if the signal is too low at the charger.
Switches inside the charger allow the maximum current to be limited where required.
Printed SDOC indluded